Archi Forum

Discussion Boards => Archi Development => Topic started by: HansBosma on March 19, 2019, 10:32:49 AM

Title: Double association relationship
Post by: HansBosma on March 19, 2019, 10:32:49 AM
A relationship is in my opinion a symmetric relationship; it just says A is associated with B. When drawing it depends, if I start drawing with A, or with B. So in many cases in multiple diagrams I end up with double associations (when I mean only one association relation).

So, should it not be the case that when drawing an association Archi Always should mention that there is already another association relationship? (when there is one of course)?
Title: Re: Double association relationship
Post by: Phil Beauvoir on March 19, 2019, 12:39:55 PM
It doesn't check for the same type of relationship in the opposite direction. Perhaps it should. Possible candidate for the "to do" list...
Title: Re: Double association relationship
Post by: HansBosma on March 20, 2019, 13:12:29 PM
Thx Phil. May I recommend it on the 'to do' list?

ps thx for the terrific tool by the way
Title: Re: Double association relationship
Post by: Phil Beauvoir on March 20, 2019, 13:13:47 PM
Yes. The next time that part of the code is looked at, I'll have a think about what can be done.